I think I saw this on Reddit, here or somewhere. I'm doing the last few clean up items after installing a v2 petsfang cooling duct on what used used to be a Creality Ender 3v2 (now more like a TH3D v2). This question will answer the same question on two near Ender 3 printers. I installed the EZABL mount that is called for with just about any Micro Swiss DD/Ender 3 style chassis. Problem is the probe is now much higher then when I was using the Blokhead. If the sensitivity adjustment screw is hidden behind either the mount or one of the probe mount nuts. Any ideas on how to tune this dude? It was tuned for the stock mount with no issues. Thanks in advance.
