Here is a 5015 fan mount for the Ender 6 using a Petsfang duct. There are versions for the EZABL and BLTouch.

Front View:

Side View:

EZABL Mount:

EZABL mount:

pfv2-e6-ezabl-v2.stl

507kB

BLT mount

v2-ender6bltbasev2a.stl

541kB

The Petsfang duct I used is the CR10TEVO_5015_DUCT_V7.5 from thingaverse

The stock cable clamp will foul the top of the Petsfang so replace it with the attached cable_clamp2.stl. This clamp mounts from the rear of the plate.

cable-clampv2.stl

199kB

Printing:

See the Petfang thingaverse page for printing suggestions for the duct: ( .2 resolution, Infill 80 - 100% or 6 walls). I printed the shroud with 25% infill and 3 walls at .2 layer height.

Prep:

Before mounting, fit three M3 nuts into the recesses on the mount and pull tight using M3 machine screws. The nut recesses have a slight draft so the nut should stay in place after being pulled into position. These will be used to secure the duct into position. There is a fourth mounting point that can take a self threading M3 screw but I found this was not essential.

Mounting:

For the shroud to fit flush to the plate, the wires to the x-axis end stop switch need to be dressed upwards to clear the shroud.

The shroud attaches using the stock M3x6 button head socket screws.

The screw on the upper right is a little tricky so start with that. Insert the screw into the printed hole and push the allen key through the channel in the shroud just below the upper right fan mounting hole. Check that the allen key is not snagging the hot end wiring. Once that screw has the mount flush against the plate, the other two are straightforward.

Attaching the ABL sensor:

The petsfang must be mounted and positioned before attaching the EZABL, otherwise you won’t be able to get at one of the petsfang mounting screws.

If using the BLTouch, you can remove one screw to swing the BLT out if the way.

Please post in this thread if you have any suggestions for improvements.

UPDATE:

Some install tips along with zip files with updated EZABL or BLTouch STLs are in this post: https://www.makerforum.tech/d/52-ender-6-5015-petsfang-mount/8

An updated EZABL mount providing easier access to adjustments screws is posted here:

https://www.makerforum.tech/d/52-ender-6-5015-petsfang-mount/11